How to solve the quality problems that occur during the die-cutting process?

The diecutting processing factory has actually had a great impact on our daily lives, but when using diecutting machinery to complete this task, there may be some small difficulties. It is different from our other equipment. Just having difficulties is equivalent to being exceptionally amateur. At the same time, we also need our amateur technicians to complete the investigation before we can finish the repair work. In order for us to easily repair die-cutting processing equipment in ordinary work, the above difficulties are the rarest. Now, let's learn from the planning introduction.  

1、 Dealing with the situation where the bottom paper of the product is punched through or continuous

9759彩票集团Under normal circumstances, when the die-cutting process is completed, there are mainly two types of situations where this type of situation occurs: one is the complete punching through phenomenon, and the other is the punching through phenomenon of the department. The first is to understand whether the knife on the applied mold is sharp enough, and to check whether the pressure generated by the die-cutting machine during operation is unstable. If the pressure is unstable, the machine must be finished and adjusted before checking the pressure stability of the machine; To deal with the difficulty of piercing through the department, the homework that should be checked is to see if the department has too many equipment pads. Normally, only two layers of tape need to be padded, and it is also possible to choose some relatively hard pad templates, such as plywood or acrylic board.  

2、 The commodities processed by die-cutting are deformed

Deformation may be due to the inability to control tension, so it is necessary to pay attention to checking the standards of the products processed by the mold before ending the processing. It is also possible to check whether the pad cotton used is suitable; Especially the difficulty of tension control, it is necessary to pay attention to it. If the tension of the applied material does not cause the processed goods to have a shortened atmosphere, then the products processed by die-cutting will deform.

3、 When processing products with small edges, there is a deformation of the product

9759彩票集团Some people may ask, if it is not mentioned that such a state has already been introduced, how can it be said again? The deformation characteristics of small edge products are different from those of large items. Therefore, let's introduce them separately. Because the margins of the processed products are very small, the punching method will be applied during the die-cutting process. The disadvantage of this method is that the standards are difficult to control, such as positioning prohibition or displacement of the produced products. In order to prevent deformation of small edge products, it is possible to first place the required standards in the mold for testing, and then end the processing after there are no difficulties.